Usb Storage General Commands Example; Vlan Interface Specific Commands - ZyXEL Communications UAG Series Reference Manual

Table 49 USB Storage General Commands (continued)
COMMAND
usb-storage mount
usb-storage umount
[no] logging usb-storage
show logging status usb-storage
logging usb-storage category
category level <all|normal>
logging usb-storage category
category disable
logging usb-storage
flushThreshold <1..100>
[no] diag-info copy usb-storage
show diag-info copy usb-storage
[no] corefile copy usb-storage
show corefile copy usb-storage

13.6.1 USB Storage General Commands Example

This example shows how to display the status of the connected USB storage device.
Router> show usb-storage
USBStorage Configuration:
Activation: enable
Criterion Number: 100
Criterion Unit: megabyte
USB Storage Status:
Device description: N/A
Usage: N/A
Filesystem: N/A
Speed: N/A
Status: none
Detail: none

13.7 VLAN Interface Specific Commands

This section covers commands that are specific to VLAN interfaces. VLAN interfaces also use many
of the general interface commands discussed at the beginning of
UAG CLI Reference Guide
DESCRIPTION
Mounts the connected USB storage device.
Unmounts the connected USB storage device.
Sets to have the UAG log or not log any information about the connected USB
storage device(s) for the system log.
Displays the logging settings for the connected USB storage device.
Configures the logging settings for the specified category for the connected USB
storage device.
Stops logging for the specified category to the connected USB storage device.
Configures the maximum storage space (in percentage) for storing system logs on
the connected USB storage device.
Sets to have the UAG save or stop saving the current system diagnostics
information to the connected USB storage device. You may need to send this file to
customer support for troubleshooting.
Displays whether (enable or disable) the UAG saves the current system diagnostics
information to the connected USB storage device.
Sets to have the UAG save or not save a process's core dump to the connected USB
storage device if the process terminates abnormally (crashes). You may need to
send this file to customer support for troubleshooting.
Displays whether (enable or disable) the UAG saves core dump files to the
connected USB storage device.
Chapter 13 Interfaces
Section 13.2 on page 86.
103