Yanmar 6LPA-STP2 Service Manual page 156

ENGINE
17. Turn (Figure 5-184, (1)) the crankshaft pulley
clockwise to check if each pulley timing mark
(Figure 5-184, (2)) matches with the top dead
center (TDC) mark. If the timing marks never
align disconnect the timing belt and reinstall it to
with the correct alignment.
Figure 5-184
(2)
Figure 5-184
18. Remove all packing material from the timing
cover sealing surfaces.
19. Apply seal packing (TOYOTA P/N 08826-00080
or equivalent) to the camshaft oil seal retainer
and timing belt cover as shown in Figure 5-185.
Figure 5-185
Figure 5-185
5-76
(2)
Figure 5-186
(1)
0005184
0005185
© 2007 Yanmar Marine International
20. Install the insulator to the timing belt cover.
21. Install the gasket to the timing belt cover.
22. Install the timing belt cover (Figure 5-186, (1))
with bolts and 3 seal washers
(Figure 5-186, (4)), 2 clamps
(Figure 5-186, (2)) and 3 clips
(Figure 5-186, (3)).
(3)
(3)
(4)
(1)
(4)
Figure 5-186
6LPA Service Manual
Timing Belt
(2)
(3)
(2)
(4)
0005186