Advertisement
14–130
ENGINE REAR OIL SEAL
REPLACEMENT
1.
REMOVE MANUAL TRANSAXLE ASSY (M/T TRANSAXLE) (See page 41–17)
2.
REMOVE AUTOMATIC TRANSAXLE ASSY (A/T TRANSAXLE) (See page 40–9)
3.
REMOVE CLUTCH COVER ASSY (M/T TRANSAXLE) (See page 42–18)
(a)
Remove the 6 bolts and clutch cover.
4.
REMOVE CLUTCH DISC ASSY (M/T TRANSAXLE) (See page 42–18)
SST
SST
SST
2004 COROLLA (RM1037U)
ENGINE MECHANICAL
–
5.
REMOVE FLYWHEEL SUB–ASSY (M/T TRANSAXLE)
(a)
Fix the crankshaft with SST, then remove the 8 bolts and
flywheel.
SST
A62838
6.
REMOVE DRIVE PLATE & RING GEAR SUB–ASSY
(A/T TRANSAXLE)
(a)
Fix the crankshaft with SST, then remove the 8 bolts and
drive plate & ring gear.
SST
A62838
7.
REMOVE ENGINE REAR OIL SEAL
(a)
Using a knife, cut off the oil seal lip.
Cut Position
(b)
Using a screwdriver with taping its tip, pry out the oil seal.
NOTICE:
After the removal, check if the crankshaft is not damaged.
If there is, mend it with a sandpaper (#400).
A62202
8.
INSTALL ENGINE REAR OIL SEAL
(a)
Apply MP grease to a new oil seal lip.
NOTICE:
Keep the lip off foreign materials.
(b)
Using SST, tap in the oil seal until its surface is flush with
the rear oil seal retainer edge.
SST
NOTICE:
Wipe off extra grease on the crankshaft.
A62203
ENGINE REAR OIL SEAL
09960–10010 (09962–01000, 09963–01000)
09960–10010 (09962–01000, 09963–01000)
09223–15020, 09950–70010 (09951–07100)
140ON–01
Advertisement
