Advertisement
14–42
SST
B
A
109. INSTALL FRONT SUSPENSION ARM SUB–ASSY LOWER NO.1 LH (See page 30–6)
110. INSTALL FRONT SUSPENSION ARM SUB–ASSY LOWER NO.1 RH (See page 30–6)
111. INSTALL FRONT STABILIZER LINK ASSY LH (See page 51–18)
112. INSTALL FRONT STABILIZER LINK ASSY RH (See page 51–18)
113. INSTALL TIE ROD END SUB–ASSY LH (See page 30–6)
114. INSTALL TIE ROD END SUB–ASSY RH (See page 30–6)
115. INSTALL FRONT AXLE HUB LH NUT (See page 30–6)
116. INSTALL FRONT AXLE HUB RH NUT (See page 30–6)
117. INSTALL EXHAUST PIPE ASSY FRONT (See page 15–2)
118. INSTALL FLOOR PANEL BRACE FRONT
(a)
Install the front floor panel brace with the 2 nuts.
Torque: 30 N⋅m (306 kgf⋅cm, 22 ft⋅lbf)
119. INSTALL STEERING INTERMEDIATE SHAFT (See page 51–18)
2004 COROLLA (RM1037U)
ENGINE MECHANICAL
(f)
(g)
B
A
A62831
(h)
(i)
(j)
SST
(k)
A62832
(l)
NOTICE:
After installing the crossmember, check that the position-
ing holes on the crossmember and vehicle are aligned with
each other.
A50337
–
PARTIAL ENGINE ASSY (April, 2003)
Insert SST to the positioning holes on the right handle
crossmember and on the right–handle of the vehicle.
SST
09670–00010
Temporarily tighten the bolt A first, then bolt B.
Insert SST to the positioning holes on the left handle
crossmember and on the left–handle of the vehicle.
SST
09670–00010
Temporarily tighten the bolt A first, then bolt B.
Insert SST to the positioning holes on the right–handle
crossmember and right–handle of the vehicle, then tight-
en the bolts with the specified torque.
Insert SST to the positioning holes on the right–handle
crossmember and left–handle of the vehicle, then tighten
the bolts with the specified torque.
SST
09670–00010
Torque:
157 N⋅m (1,601 kgf⋅cm, 116 ft⋅lbf) for bolt A
113 N⋅m (1,152 kgf⋅cm, 83 ft⋅lbf) for bolt B
Tighten the 2 bolts, as shown in the illustration.
Torque: 39 N⋅m (398 kgf⋅cm, 29 ft⋅lbf)
Advertisement
