Advertisement
Pry
SST
10.
INSTALL FRONT WHEEL RH
Torque: 103 N⋅m (1050 kgf⋅cm, 76 ft⋅lbf)
11.
CHECK ENGINE OIL LEAK
2004 COROLLA (RM1037U)
ENGINE MECHANICAL
–
6.
REMOVE TIMING GEAR COVER OIL SEAL
(a)
Using a knife, cut off the oil seal lip.
Cut Position
(b)
Using a screwdriver with taping its tip, pry out the oil seal.
NOTICE:
After the removal, check if the crankshaft is not damaged.
If there is, mend it with a sandpaper (#400).
A62183
7.
INSTALL TIMING GEAR COVER OIL SEAL
(a)
Apply MP grease to a new oil seal lip.
NOTICE:
Keep the lip off foreign materials.
(b)
Using SST, tap in the oil seal until its surface is flush with
the timing chain cover edge.
SST
NOTICE:
Wipe off extra grease on the crankshaft.
A62184
8.
INSTALL CRANKSHAFT PULLEY
(a)
Align the pulley set key with the key groove of the pulley,
and slide on the pulley.
(b)
Using SST, install the crankshaft pulley bolt.
SST
Torque: 138 N⋅m (1,407 kgf⋅cm, 102 ft⋅lbf)
A62837
9.
INSTALL
SUB–ASSY RH
(a)
Install the engine mounting insulator RH with the 4 bolts
and 2 nuts.
Torque: 52 N⋅m (530 kgf⋅cm, 38 ft⋅lbf)
A64005
TIMING CHAIN OR BELT COVER OIL SEAL
09223–22010
09960–10010 (09962–01000, 09963–01000)
ENGINE
MOUNTING
14–129
INSULATOR
Advertisement
