Table of Contents
Advertisement
Notification Setup
Maintenance
The recorder can be set up to contact a computer when an event occurs. Highlight the box under the "No."
heading and press the
addresses if "No." is enabled.
Highlight the "IP Address" box that you want to change and press the
to enter the IP address of the computer you want contacted during an event. You can enter up to five IP
addresses.
Highlight the box beside "Retry" and enter the number of times you would like the recorder to try contacting
the computer. You can select from 1 to 10 retries.
The recorder can be set up to send an email when an event occurs. The Mail Group and Recipient can
be turned On or Off by highlighting the boxes beside the individual mail group and recipient accounts and
pressing the
button. Highlighting the box beside "Group & Recipient" and pressing the
between all mail accounts being turned On and Off.
Figure 55: Notification – Maintenance setup screen
button to toggle between On and Off. You will only be able to change the IP
Figure 56: Notification – Mail setup screen
button. Use the arrow buttons
button will toggle
49
Advertisement
Table of Contents
