Fen; Figure 51: Network - Lan (Dhcp) Screen; Figure 52: Network - Fen Setup Screen - Panasonic WJ-HL208A Operating Instructions Manual

Note: For the UPnP service to work, the NAT device should support the UPnP Port Forwarding
function and the function should be set to enabled.
You cannot change the port settings when "Use UPnP" is On.
Highlight the "Status" box and press the
via UPnP service.
Highlight the "Test" box and press the
Selecting "DHCP" from the Type and highlighting "Save" button reads the current IP address of the recorder
configured by DHCP (Dynamic Host Configuration Protocol) network.
Highlight "Auto" (Default) and press the
will obtain the IP address of the DNS server automatically.
Note: Selecting "Auto" will only be enabled when the recorder is configured for DHCP.
If the recorder is configured for DHCP, the IP address of the recorder might change whenever
the unit is turned on.

FEN

Highlight "Use FEN" and press the
46
button to display the port numbers forwarded from the NAT device
button to test the current LAN settings you made.
Figure 51: Network – LAN (DHCP) screen
button to toggle between On and Off. When it is On, the recorder
Figure 52: Network – FEN setup screen
button to toggle between On and Off.