Table of Contents
Advertisement
Note: FEN (For Every Network) is the technology that automatically sets up your recorder to work
seamlessly for remote viewing via your network internet connection. For FEN to work, naming
your recorder will be required.
Highlight the box beside "FEN Server" and press the
enter the IP address or domain name of the FEN server.
Note: You will need to get the IP Address or domain name of the FEN Server from your network
administrator.
You can use the domain name instead of IP address if you already set up the DNS Server when
setting up the LAN.
Highlight the box beside "Port" and press the
and Down arrow buttons to increase or decrease the numbers.
Highlight the box beside "FEN Name" and press the
enter the recorder name to be registered on the DVRNS server.
Highlight the "Check" box and press the
used.
Note: The FEN Name you entered should be checked by selecting Check, otherwise the FEN changes
will not be saved.
When entering no name or a name already registered on the DVRNS server, an error message
displays.
The box beside "Status" displays the current information of the Rendezvous server and NAT (Network
Address Translation) device.
RTSP
Highlight "Enable RTSP" (Real-Time Streaming Protocol) and press the
Off. You will be able to change the settings if Enable RTSP is enabled.
Highlight the box beside "RTSP Port" and press the
obtained from your system administrator.
Highlight the box beside "RTP Start Port" and press the
obtained from your system administrator.
Highlight the box beside "RTP End Port" and press the
obtained from your system administrator.
Highlight "Narrow Bandwidth Mode" and press the
you can access a remote recorder through the narrow bandwidth network.
button. A virtual keyboard appears allowing you to
button. Set the port number of the FEN server using the Up
button. A virtual keyboard appears allowing you to
button to check whether or not the name you entered can be
Figure 53: Network – RTSP setup screen
button. Set the port number of the RTSP server
button to toggle between On and Off. When set to on,
button to toggle between On and
button. Set the start port number of the RTP server
button. Set the end port number of the RTP server
47
Advertisement
Table of Contents
