Event Setup; Motion; Figure 31: Event - Motion Setup Screen; Figure 32: Motion Detection Sensitivity Screen - Panasonic WJ-HL208A Operating Instructions Manual

Event Setup

Motion

Your recorder has built-in video motion detection. Video motion detection can be turned On or Off for each camera.

Figure 32: Motion Detection Sensitivity screen

You can define the area of the image where you want to detect motion; e.g., a doorway. Highlight the box
under the "Zone" heading, and press the

Figure 33: Motion Detection Zone screen

Press the button to display the menu screen. The menu on the setup screen has the following functions:
Select: Activates highlighted blocks to detect motion.
Clear: Deactivates highlighted blocks so that they will not detect motion.
Reverse: Activates inactive highlighted blocks and deactivates active highlighted blocks.
Select All: Activates all blocks to detect motion.
Clear All: Deactivates all blocks so that they will not detect motion.
Reverse All: Activates inactive blocks and deactivates active blocks.
Zone View: Displays any detected motion within the zone in red.
OK: Accepts changes and closes Zone setup.
Cancel: Exits Zone setup without saving changes.

Figure 34: Motion Detection Zone menu

36
Figure 31: Event – Motion setup screen
Highlighting the box under the "Sensitivity" heading and pressing the
button allows you to adjust the recorder's sensitivity to motion for
"Daytime" and "Nighttime" independently. There are five settings with "1"
being the least sensitive and "5" being the most sensitive.
button. The Motion Zone screen displays.
The Motion Zone screen is laid over the video for the
selected camera. You can set up motion zones by selecting
or clearing blocks.
Note: You can set up motion zones one block at a time
in groups of 8 individual block groups. A block
group is positioned within the image area using
the Up and Down arrow buttons, and individual
blocks within the block groups are selected or
cleared using the camera buttons.