Figure 70: Sequence Pattern - Panasonic WJ-HL208A Operating Instructions Manual

Digital disk recorder

Hide thumbs

Table Of Contents

Table of Contents

9 Sequence

Selecting " " (Sequence) in the Live Monitoring menu causes the cameras to display sequentially. It is the

same as pressing and holding the [SEQUENCE] button for three seconds or longer. When in one of the multi-

view formats, selecting " " will cause the recorder to go through predefined screen layouts (Full Sequence).

Or, the bottom, right screen will display live cameras sequentially (Partial Sequence). For example, if you

select " " in the 2x2 format, the recorder changes pages as follows:

Selecting " " again in the Live Monitoring menu exits the Sequence mode. While in the Sequence mode, the

icon displays in bottom-left corner if Sequence is selected in the Display setup screen ("OSD" tab). If all

the cameras in a page are Off, or have lost video or are set to Covert (unless the user has authority to view

covert cameras), that page will be excluded from the sequence.

Note: The "Full Sequence" for the full sequence monitoring and the "Partial Sequence" for the Partial

sequence monitoring should be selected in the Display setup screen ("Main Monitor" tab).

: Camera Menu

p p PTZ: Selecting "

" (Camera Menu) → "PTZ" and choosing the camera number allows you to control the

selected camera as long as it has Pan, Tilt and EL-Zoom capabilities. It is the same as pressing the [PTZ]

button. Refer to the following "PTZ Mode" section for details.

p p EL-Zoom: Selecting "

current image of the selected camera on the screen. It is the same as pressing the [EL-ZOOM] button.

Selecting "EL-Zoom" again in the Camera Menu again exits the EL-Zoom mode. Refer to the following

"EL-Zoom Mode" section for details.

p p Audio: Selecting "

p p Color Control: Selecting "

you to control brightness, contrast, hue and saturation for each camera for the selected camera if a user

who has "Color Control" authority logs into the system. It is the same as pressing and holding a camera

button for a few seconds.

p p Edit Group: Selecting "

as pressing and holding the [EDIT GROUP] button for three seconds or longer in any multiview formats.

Refer to the following "Live Monitoring – Edit Group Mode" section for details.

Note: It is important that cameras and monitors are correctly installed and adjusted prior to making

any image adjustments using the recorder's controls.

Any image adjustments you make will be applied to both the live video on the monitors and the

recorded video.

The "Camera Menu" also can be displayed by clicking the right mouse button on the screen

while in the live monitoring mode.

; Search

p p All Channels: Selecting "

search mode. It is the same as pressing the [PLAYBACK] button.

p p Triplex: Selecting "

back video of the selected camera.

< Full Sequence >

< Partial Sequence >