Table of Contents
Advertisement
< Setup
Selecting "
" (Setup) in the Live Monitoring menu enters the Main Setup screen. Refer to "Chapter 3 ─
Configuration" for detailed descriptions of system setup.
= Status
Selecting "
" (Status) in the Live Monitoring menu allows you to check the status of the recorder's system,
inputs and storage. Refer to the following "Live Monitoring – Event Status" section for details.
Note: Selecting "Status" will only be enabled for a user who has "System Check" authority.
Edit Group Mode
You can enter the Edit Group mode by selecting "Edit Group" from the Live Monitoring – Camera menu or
pressing and holding the [EDIT GROUP] button for three seconds or longer in any multi-view format. The
yellow outline surrounding the video indicates the active channel, and pressing the arrow buttons moves the
active channel. Pressing the
the Edit Group menu displayed when pressing the [EDIT GROUP] button also exits the Edit Group mode. The
Edit Group mode will remains in effect for 15 seconds if there is no further operation.
In Edit Group mode, press the button for the camera you want to display in the active screen. After setting
the camera number to active screen, the recorder moves the active screen to the next channel. When the
camera number exists on the current screen, the active screen is changed with the existing camera number.
When the camera number does not exist on the current screen, the active screen is replaced by the camera
number. You can change the screen layout in this way.
Note: The recorder will not display video if you [EDIT GROUP] bottom-right area on 3x3 format.
EL-Zoom Mode
You can enlarge an area of the video by pressing the [EL-ZOOM] button. For a few seconds after pressing the
[EL-ZOOM] button, a rectangle displays on the screen. A rectangle shows the area that will be enlarged. You
can move the rectangle around using the arrow buttons. Pressing the
mode enlarges the area in rectangle. Exit the EL-Zoom mode by pressing the [EL-ZOOM] button. While in the
EL-Zoom mode, the icon
PTZ Mode
If a user who has "PTZ Control" authority logs into the system, the user can control PTZ cameras. The
recorder will control cameras with Pan, Tilt and EL-Zoom capabilities. Press and hold the [PTZ] button for
three seconds or longer to display the PTZ camera menu and enter the PTZ mode, and press the button
again to exit the PTZ mode.
Select the PTZ camera you wish to control by selecting it from the menu. The icon
camera screen.
Figure 71: PTZ Select Camera menu
58
(Play/Pause) button exits the Edit Group mode. Selecting "Exit Group Edit" in
displays if "EL-Zoom" is selected in the Display setup screen ("OSD" tab).
To use the front panel buttons, press the Left and Right arrow buttons to pan left and
right. Press the Up and Down arrow buttons to tilt the camera up and down. Press the
"ZOOM +" button to zoom in, and press the "ZOOM –" button to zoom out. You can
use the "FOCUS NEAR" and "FOCUS FAR" buttons to focus the image.
You can establish preset positions for PTZ cameras. Press the "PRESET SET" to
establish Presets.
You can quickly move PTZ cameras to Preset positions. Press the "PRESET VIEW" to
view an established camera Preset position.
(Play/Pause) button in the EL-Zoom
displays on the PTZ
Advertisement
Table of Contents
