Table of Contents
Advertisement
LAN
Highlight the box beside "Type" and press the
from: "Manual" and "DHCP". Select the desired type and press the
Selecting "Manual" from the Type allows you to set up LAN parameters manually.
Change the numbers by highlighting them and using the Up and Down arrow buttons to increase or decrease
the number.
The factory default LAN settings are:
p p IP Address:
192.168.0.250
p p Gateway:
192.168.0.1
p p Subnet Mask: 255.255.255.0
Note: You will need to get the appropriate IP Address, Gateway and Subnet Mask from your network
administrator.
Highlight the box beside "DNS Server". Press the Up and Down arrow buttons to set the IP address of the
DNS server.
Highlight the "Port Number Setup..." box and press the
Note: You will need to get the appropriate Port Numbers for Web Browser related program (Status,
Callback, Watch and Search) from your network administrator.
Figure 50: Port Number Setup screen
Note: The system restarts automatically after changing the port settings.
Do NOT use the same port number for two different programs, otherwise, the recorder cannot
be connected with Web Browser.
Important: When changing the port settings, you must change the port settings on Web Browser as
well.
Highlight "Use UPnP" and press the
from the NAT (Network Address Translation) device to the recorder will be enabled automatically via UPnP
(Universal Plug and Play) service. This function will be especially useful when accessing a port on a private
IP address.
Figure 49: Network – LAN setup screen
button. You can select the type of network configuration
Change the numbers by highlighting them and using the Up and
Down arrow buttons to increase or decrease the number.
The factory default Port settings are:
p p Remote Status:
p p Remote Callback: 8201
p p Remote Watch:
p p Remote Search:
button to toggle between On and Off. When it is On, port forwarding
button.
button. The "Port Number Setup" screen appears.
8200
8016
10019
45
Advertisement
Table of Contents
