Table of Contents
Advertisement
Live Monitoring Menu
1 Login/Logout
Selecting " " (Login) in the Live Monitoring menu accesses the Login screen, and you will be asked to select
a User and enter the password to log into the system. Selecting " " (Logout) in the Live Monitoring menu
displays the Logout screen asking you to confirm whether or not you want to log out the current user.
2 Monitor
Selecting " " (Monitor) in the Live Monitoring menu will allow you to select the monitor from "Main Monitor"
and "Spot Monitor". Selecting "Spot Monitor" displays a Spot Monitor menu on the right edge of the screen
and allows you to control a Spot Monitor. Refer to the following "Spot Monitoring" section for details.
3 Multi Screen
p p Full Screen: Selecting " " (Display) → "
displays the selected camera full screen. It is the same as pressing the individual camera buttons on the
front panel or clicking the left mouse button on a camera image when in one of the multiview formats (i.e.,
2x2, 1+5, 1+7 or 3x3).
Clicking the left mouse button on the screen again returns to the previous display mode.
p p PIP, 2x2, 1+5, 1+7, 3x3: Selecting " " (Display) → "
displays the cameras in the selected multiview screen mode (PIP, 2x2, 1+5, 1+7 or 3x3). Selecting each
display mode is the same as pressing the [MULTI SCREEN] button or scrolling the mouse wheel up and
down when in one of the multiview formats (i.e., 2x2, 1+5, 1+7 or 3x3).
Note: In the 1+5 or 1+7 display mode, the main channel indicates the channel displayed on the large
screen which is displayed in the top-left. You can select the camera you want to display on
the main channel screen. Select a channel on the screen and click the right mouse button to
display the Camera Menu.
Selecting "Go To Main" swaps the selected channel with the main channel. This function is
supported only in the 1+5 and 1+7 display modes and can be activated from any of channel
screens except the main channel screen.
p p Camera OSD, Status OSD: Selecting " " (Display) → "Camera OSD" or "Status OSD" toggles Camera
OSD or Status OSD On and Off.
4 Previous Group, 5 Next Group
Selecting " " or " " (Previous Group or Next Group) in the Live Monitoring menu moves to the previous or
next page. It is the same as pressing the [NEXT GROUP] button.
6 Freeze
Selecting " " (Freeze) in the Live Monitoring menu will freeze the current image on the screen until you
select " " again.
It is the same as pressing the
and [PANIC] buttons while in the Freeze mode can also exit the Freeze mode. While in the Freeze mode, the
icon
displays in bottom-left corner if "Freeze" is selected in the Display setup screen ("OSD" tab).
7 Alarm
Selecting " " (Alarm) in the Live Monitoring menu resets the recorder's outputs including the internal buzzer
during an alarm. It is the same as pressing the [ALARM] button.
8 Panic
Selecting " " (Panic) in the Live Monitoring menu starts panic recording of all cameras, and selecting " "
again stops panic recording. It is the same as pressing the [PANIC] button.
56
" (Full Screen) and choosing the camera number button
(Play/Pause) button. Pressing any button except for the [MENU], [ALARM]
", "
", "
", "
" or "
" (PIP, 2x2, 1+5, 1+7 or 3x3)
Advertisement
Table of Contents
