CYBEX 770T Owner's Manual page 6

Keep the running belt clean and dry at all times.
•
DO NOT leave the treadmill unattended when plugged in and running. NOTE: Before leaving the
•
treadmill unattended, always wait until the treadmill comes to a complete stop and is level. Then,
turn all controls to the STOP or OFF position and remove the plug from the outlet. Remove the
e-stop key from the treadmill.
Immobilize the treadmill (when not in use) by removing the e-stop key.
•
Inspect the treadmill for worn or loose components before each use. Do not use until worn or
•
damaged parts are replaced.
Stop and place the treadmill at 0 degrees incline (level) after each use.
•
Maintain and replace worn parts regularly. Refer to "Preventive Maintenance" section of Owner's
•
Manual.
DO NOT operate the treadmill if: (1) the cord is damaged; (2) the treadmill is not working properly
•
or (3) if the treadmill has been dropped or damaged. Seek service from a qualified technician.
DO NOT place the cord near heated surfaces or sharp edges.
•
DO NOT use the treadmill outdoors.
•
DO NOT operate the treadmill around or where aerosol (spray) or where oxygen products are
•
being used.
Ensure all users wear proper footwear on or around all Cybex equipment.
•
Disconnect power before servicing.
•
DO NOT attempt repairs, electrical or mechanical. Seek qualified repair personnel when servicing.
•
If you live in the USA, contact Cybex Customer Service at 888-462-9239. If you live outside the
USA, contact Cybex Customer Service at 508-533-4300.
Use Cybex factory parts when replacing parts on the treadmill.
•
DO NOT modify the treadmill in any way.
•
DO NOT use attachments unless recommended for the treadmill by Cybex.
•
Cybex Owner's Manual
6