CYBEX 770T Owner's Manual page 40

Auto Program (ATSC Monitor)
1. Tap ▼ to select Auto Program.
2. Tap ► to enter the menu.
3. Tap ▲ or ▼ to select Mode.
4. Tap ◄ or ► to set the scope of channel scanning.
Analog Only (Default): TV searches for analog channels only.
•
Digital Only: TV searches for digital channels only.
•
Analog and Digital: TV searches for both analog and digital channels.
•
5. Tap ▼ to select Channel Sequence.
6. Tap ◄ or ► to set the Channel Sequence in which the channels are displayed after searching.
Interleave A+D: In the order of channel number regardless of the system.
•
All A then D: Digital channels are displayed after all analog channels.
•
7. Tap ▲ or ▼ to select Additional Digital Signal. Not available when Mode is set to Analog
Only.
8. Tap ◄ or ► to choose the Additional Digital Signal source. Choices are: None, Air, Cable
STD, Cable IRC, or Cable HRC.
9. Tap ▼ to select Channel Map.
10. Tap ► to start auto programming. A confirmation menu will appear before proceeding.
11. Tap ▲(Yes) to start auto programming. Tap ▼(No) button to cancel the operation. The TV
will now search all available channels with an on-screen progress percentage displayed.
Any tuning Mode that includes Digital channels will require several minutes to complete auto
programming.
This may take 20 or more minutes. If screen shuts off, tap the
12. Tap the Setup
Cybex Owner's Manual
ATSC Monitor
Auto Program
■ Mode
■ Channel Sequence
■ Additional Digital Signal
■ Channel Map
Position: ▲ ▼
Exit: SETUP
icon to return to normal TV viewing once auto programming is complete.
Analog Only
Interleave A + D
None
Programmed ►
Next: ◄ ►
icon to turn monitor on.
40