Setup - CYBEX 770T Owner's Manual

Setup

Use the following instructions to setup the unit.
WARNING: Falling hazard.
When starting unit
Stand on two top steps.
•
Do not stand on belt.
•
Cybex recommends that the treadmill be unplugged or the on/off (I/O) power switch turned off (O)
when it is not in use.
1. Without anyone on the treadmill, plug the power cord into a power outlet from a grounded,
dedicated circuit as described under Electrical Requirements in this chapter.
Ensure the power cord is not being pinched under the front of the treadmill.
2. Locate the on/off (I/O) power switch under the front end of the treadmill. Toggle it to the on
position (I).
3. The control panel will light up.
Initial setup
Initial setup only occurs during the installation of the unit. Once complete, refer to Setup Options
below.
ENGLISH
1. Press the Access Toolbox icon to display the Access to Toolbox login screen.
2. Enter the sequence:
3. Press the Setup icon to display the setup menu.
4. Tap the Time icon to advance to the Set the Time screen.
5. Adjust the time if needed, then tap the ENTER icon
6. Tap the Date icon to advance to the Set the Date screen.
7. Adjust the date if needed, then tap the ENTER icon
8. Tap the Units & Power icon to select the Set units preference screen.
Cybex Owner's Manual
CYBEX Press and hold Cybex logo for 6 seconds to access Screen
LOGO
Lock and Toolbox. See Preventive Maintenance section.
LANGUAGE Press and hold language logo for 6 seconds to access
ICON Screen Lock and Toolbox.
.
.
.
28