2.8
Transmit Motor (324)
(3)
(5)
(1) Remove the Transmit Guide (301) Assembly
(Refer to 2.5).
(2) Remove the Stamp Assembly (325, 326) (Refer to 2.6).
(3) Disconnect the Harness (340) from the Transmit Motor.
(4) Remove the ADF Gear (305) and ADF Angular
Shaft (338).
Caution:
When removing the ADF Gear, rotate the Transmit Motor
(4)
Gear by hand until the Gear Latch Hook can be seen from the
inside, under the Transmit Motor. Push down on the Latch
Hook to release the ADF Gear.
(5) 2 Screws (19).
(6) Remove the Transmit Motor (324).
(6)
Caution:
Reinstall the Transmit Motor (324) according to the direction
shown in the illustration.
Caution:
Before reassembling, apply EM-50L Grease to the Gear Posts
shown by the arrows in the illustration.
28