Olg Flexible Access Code Programming; Creating The Channel Group; Service Definition - Toshiba IP edge EP Installation Manual

Hide thumbs Also See for IP edge EP:
Table of Contents

Advertisement

OLG FLEXIBLE ACCESS CODE PROGRAMMING

OLG FLEXIBLE ACCESS
CODE PROGRAMMING
Creating the Channel
Group

Service Definition

Installation Manual
August, 2011
10. Leave the remaining parameters blank.
11. Click on the Save icon.
Note:
Notice that Incoming and Outgoing trunk group with the same
Trunk Group Number have been created.
An access code is required for the OLG that was setup for the SIP
Trunks. SIP trunks can also be accessed using LCR.
1. Select System > Flexible Access Code.
2. Click on the New icon.
3. Enter the Access Code.
4. Select Feature Name; Line Group access code.
5. Select the OLG.
6. Click on the Save icon.
Important!
Complete the Channel Group programming before
starting the Service Group programming.
1. Select Trunk > SIP Trunking.
2. In the Channel Group tab select the SIP Trunk Channel Group to be
created.
Note:
Choose a Channel group number that has not been assigned in
another section.
When a Channel Group is selected for a SIP trunk that Channel
group number cannot be used for IPedge Net.
3. In the SIP Trunk Channels box select the TOTAL number of ports to
be dedicated to the SIP trunk channel group.
4. Click on the Save icon.
1. Click on the Service Definition tab.
2. Click on the New icon.
3. Select a Service Definition Index number then, enter the following
based on the SIP Trunk Provider:
Registration Mode - Client or none
Domain Name - The domain name of the SIP Trunk provider (FQDN)
or the IP address.
SIP Server - The SIP Trunk provider outbound proxy or blank.
4. Enter the ILG and OLG created above.
5. Select the number of trunks/channels provided by this SIP trunk
provider as the Effective Channel Number.

Creating the Channel Group

11-5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ip edge emIp edge ec

Table of Contents