Detach A Member Node - Toshiba IP edge EP Installation Manual

DETACH A MEMBER NODE

DETACH A MEMBER
NODE
Installation Manual August, 2011
The following procedure covers the steps taken to detach a member node
from the primary server in an enterprise system. Detaching a node
changes that node from a member of an enterprise to stand alone,
primary server. After the node is detached it will not accept programming
changes from any other node. If the node was a member of an IPedge
Network, it will continue to function as a part of the network. Note that any
changes made to other nodes in the network that effect network operation
will also need to be made to the detached node.
1. Toshiba recommends that you perform a full backup of the database
on the server you are going to detach before starting this procedure.
2. Login to the Primary node.
3. Select Administration > Enterprise > Servers.
4. Click to check-mark the Server Name of the node to be detached.
5. Click on the Detach Server icon.
6. In the address field of your web browser enter the IP address of the
member node you are detaching. Click on Show local login.
7. Login to the node. Click on the Server Management button.
8. Click on the Primary Server radio button. Then, click on the Save
icon.
9. Click on OK.
10. The server is no longer a member of the enterprise. It is now a stand
alone system. Select Administration > Enterprise > Servers.
Notice that the icon in the Primary Server Information section of the
screen shows that the database is updating. The Bacula application
on this server is creating a backup of the database. Please wait until
the backup is complete before making any additional changes.
Note: This process may take several minutes, depending on the size of
the database. You may logout of Enterprise Manager at this time.
MEETING IP Address Change Procedure
4-21