EP SERVER CHASSIS INSTALLATION
EM Server Bezel
EP SERVER CHASSIS
INSTALLATION
Figure 2-13 IPedge EP server - Horizontal and Vertical Shelf Mount
2-14
1. After the chassis has been secured to the rack place a key into the
slots on each end of the bezel.
2. Rotate the keys 90 degrees.
3. Place the bezel on the front of the chassis.
4. Rotate the keys 90 degrees then, remove.
5. Store the keys in an appropriate location.
The (P/N: I-EM-BZL-1A) bezel can be attached directly to the EM Server
chassis.
1. Remove the handles from the front of the server.
2. Attach the server handles received i the bezel kit.
3. After the chassis has been secured to the rack place a key into the
slots on each end of the bezel.
4. Rotate the keys 90 degrees.
5. Place the bezel on the front of the chassis.
6. Rotate the keys 90 degrees then, remove.
7. Store the keys in an appropriate location.
The IPedge EP server can be placed on a table or shelf. Refer to
2-13.
The location chosen must be free of vibration and the temperature must
meet the requirement shown in
Chapter 2
–-7.
"Environmental Specifications" on page
Installation Manual
EM Server Bezel
Figure
August, 2011