Programming The Remote Control - Toshiba RS-TX20 Viewer's Manual

Programming the Remote Control

After you complete Guided Setup (see Chapter 2), you can program the
TV POWER, VOL, and MUTE buttons to control your TV*:
1. Find the four-digit codes for your TV brand. Press the TiVo button on the
®
remote control to go to TiVo Central . Select Messages & Setup, then
Settings, then Remote Control & DMS Front, then Remote Control - TV
(power, volume, mute).
2. Prepare the remote control. Point the remote away from your Digital Media
Server (DMS) and cover the front end with your hand. Press and hold the
TV POWER button and TiVo button simultaneously for about 5 seconds
(until the red light at the end of the remote control comes on, remains
steady, then stays on when you release the buttons).
3. Enter a code. Use the number buttons on the remote to enter a four-digit
code (starting with the first code in the list on the screen). After you press
the fourth digit of the code, the red light on the end of the remote control
should flash three times and then go out.
4. Test the code. Point the remote towards the TV and press the TV POWER
button. If pressing the button turns the TV off, you're finished. If it does
not work, repeat steps 2 and 3 using the next code in the list. If none of
the codes work, see Chapter 6 of this guide for alternatives.
See Chapter 6 for more information about programming the DMS remote control.
Inserting Batteries into the Remote Control
Hold the remote with the battery door facing you. Place your thumb in
the depression of the door and slide the door towards you.
Insert two AA batteries (supplied). Be sure to match the + and - marks
on the batteries to the + and - marks in the compartment.
Replace the battery door by sliding it back into the case with the tabs
towards the rear of the compartment. You'll hear a click when it's
securely back in place.
Remote Control Tips
Press the TiVo button once to go to TiVo Central, or twice to go to the
Now Playing list.
Press LIVE TV/GUIDE to watch live TV. Press it again to see the
program guide.
Press FORWARD ( ) and BACK ( ) up to 3 times for 3 speeds.
Press PLAY to resume normal play.
INSTANT REPLAY replays the last 8 seconds of a program.
CHAN UP/DOWN does more than change the channel—it also pages
up or down through lists of programs or menu items. It skips to
the next (or previous) chapter or track when playing a DVD or CD.
Press the DVD button to go to the DVD screen. Use TOP MENU and
MENU to navigate a particular DVD's menus. (These may work
differently for different DVDs.) Press RETURN to return to a
previous DVD menu.
Press CLEAR to delete a title in a list (like the Now Playing list) or to
hide things that aren't part of the program you're watching (like
the channel banner).
INFO brings up the channel banner. Press the RIGHT arrow
to switch among three versions of the banner, each with a
different amount of information.
When you're watching "behind" live TV (for example, if you paused
live TV and later resumed watching from the paused spot),
ADVANCE catches you up to the live broadcast. In a recorded
program, press it once to jump to the end of the program, then
again to jump to the beginning.
If programmed, the TV POWER, VOLUME, MUTE, and TV INPUT
buttons can control your TV and A/V equipment.
Remote Active Light
TiVo Button
Arrow Buttons
TV Power
TV Input
DVD
Angle
DVD
Select
Thumbs Down
Mute
Chan
Vol
Volume Page
Play
Pause
Back (rewind)
Slow
Instant Replay
Top Menu
Stop
1 2 3
Number Buttons
4 5 6
9
7 8
Clear/Return
0
Live TV/Guide
Info
Angle
Thumbs Up
Chan/Page
Skip Forward
Skip Back
Record
Forward
Advance
Menu
Stop
Enter