Em Server; Dimensions; Environmental Specifications; Input Power - Toshiba IP edge EP Installation Manual

Hide thumbs Also See for IP edge EP:
Table of Contents

Advertisement

EM SERVER

EM SERVER

Dimensions

Environmental
Specifications

Input Power

EM Front Panel
Buttons
LEDs
2-4
For IPedge systems of up to 1000 users. This server has two, front
access 3 GB hard disk drives. RAID 1 configuration is available as an
option.
The IPedge EM server supports IPMI (Intelligent Platform Management
Interface) 2.0.
Height 1.7 in. (43 mm) 1U
Width 17.2 in. (437 mm) Fits a standard 19 inch rackmount.
Depth 25.6 in. (650 mm)
Gross Weight 33lbs (15.0kg)
Operating Temperature: 10° to 35°C (50° to 95°F)
Storage Temperature: -20° to 60°C (-4° to 140°F)
Operating Relative Humidity: 8% to 90% (non-condensing)
Server generates approximately 778 BTUs per hour (867 BTUs Max.)
The IPedge EM server has two redundant, hot-swap power supplies. The
server can run indefinitely on one supply.
100 ~ 240 VAC, 50 ~ 60Hz
Peak load: 250 W, 2.1 Amp at 120 VAC (tested)
Maximum Inrush Current: 10.4 Amp
The front panel of the IPedge EM server has push-button switches and
LED indicators. the hot-swappable disk drives are accessible from the
front. Refer to
Figure
2-4. The redundant power supplies are accessed
through the rear panel. All cable connections are on the rear panel.
Power On/Off Button - This applies or removes system power. When the
power is turned off using this button main power is shut off but standby
power to the system remains on. To completely remove power from the
system use this button to shut down the system then, disconnect both AC
power cords.
System Reset Button - Press and release to reset then, reboot the
server.
UID Button - Unit Identifier: Press once, an LED on the front panel and
an LED on the rear panel illuminate. The LEDs remain lit until the ID
button is pressed again.
Power LED - Indicates that system power is on when illuminated.
Disk drive activity LED - Lights while a hard disk drive or the DVD-ROM
drive is accessed.
NIC 1 - Indicates activity on the LAN 1 connection
Dimensions
Installation Manual
August, 2011

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ip edge emIp edge ec

Table of Contents