EP SERVER CHASSIS INSTALLATION
Figure 2-15 Right side Rackmount Bracket
Figure 2-16 Left Side Bracket with Power Supply
2-16
2. Attach the left side bracket with the three screws provided.
3. Place the power supply on the bracket and secure with the supplied
cable tie as shown in and
4. Attach the DC power cable to the rear panel power connector.
5. Attach the AC power cord to the power supply.
Important!
Do not plug the AC power cord into a power outlet until
instructed to in the install instructions in Chapter 4 of this
manual.
6. Attach the chassis brackets to the equipment rack with four screws.
2-16
Installation Manual
Rack Mount
August, 2011