6400-Lu3-Dse-Local Sna 3174 Control Unit - IBM 6400 Setup Manual

R1.PR1
CLASS=A,NOSEP,PRWIDTH=132,NOFCBLOD,WS=(W,R,Q,PMD,LIM,F,
T/C,P),
DESTID NAME=P6400,DEST=R1
Step 4 – Define to CICS or another application program
An application program must provide the SCS commands to control the
printer. CICS, VPS, and other applications support SCS as well as numerous
application programs, both customer written and vendor supplied. Refer to
the vendor documentation for defining an SCS printer to the program for its
use. If there is no specific information on the 6400 you may use the IBM
4234 for reference.
Step 5 – Printer Settings
It is recommended that the following printer settings be changed from
factory default settings:
Printer Control => Interface Selection => Coax
Coax Interface => Format Control => Enable
6400–LU3–DSE–Local SNA 3174 Control Unit
LU3–DSE mode is utilized when no host printing controls are required to
accomplish the print function desired. The printer settings will be used and
cannot be overridden by the host system. An existing local 3174
SNA–connected control unit is assumed. The steps required to install an
LU1–DSE printer for host definitions are as follows:
D–10 6400 Line Matrix Printers Setup Guide, Cabinet and Pedestal Models
SETUPHDR,CONSOLE (SETUPHDR=PDIR JES2 V3)
CKPTPAGE=30
1. Define to VTAM by adding logmode entry to VTAM Logmode
Table
2. Define to JES2 (Not required but recommended. See details
below)
3. Define to CICS or another Application Program such as VPS or
JES328X products.
4. Select the options on the printer that are appropriate for the
environment.