Print Language; Print Character Table; Active Print Language; Pa1 - IBM 6400 Setup Manual

Print Language

PRINT LANGUAGE specifies the set of print languages used by the printer.
Refer to Figure 4–7 for print language menus.
STANDARD PRINT LANGUAGE (the default)
ALTERNATE PRINT LANGUAGE provides code pages compatible
with 6408/6412 Model CT0 printers. Use this option with the 3287
printer emulation.
Specifying a print quality of OCR A or OCR B will change the print
language to OCR A or OCR B.
When OCR A or OCR B is selected as the default print language, OCR A
and OCR B are the only available values for this parameter. If a different
print quality value is desired, the print language must be changed first.

Print Character Table

PRINT CHARACTER TABLE prints out a table of the coax interface current
character set.
All coax character sets are shown in the 6400 Coax/Twinax Programmer's
Reference Manual.

Active Print Language

ACTIVE PRINT LANGUAGE specifies which print language set will be the
active set.
STANDARD PRINT LANGUAGE (the default)
ALTERNATE PRINT LANGUAGE

PA1

PA1 is only valid when the printer is in the NOT READY state and the coax
System Network Architecture Character Set (SCS) data stream is active. This
function displays the "PA1 ENABLED" message when the Enter key is
pressed and sends a special operator request to the host when the printer is
made READY.
Refer to the 6400 Coax/Twinax Programmer's Reference Manual for more
information about SCS.
NOTE: Selecting the PA1 menu item again ("PA1 DISABLED" appears on
the operator panel) or selecting the PA2 menu item will reset the
pending PA1 function.
Chapter 4. Configuration Menus 4–31