IBM 6400 Setup Manual page 242

Fault
Message
001 END OF FORMS
LOAD FORMS
002 FORMS JAMMED
CLEAR JAM AND RELOAD FORMS
003 FORMS EJECTED
PRESS EJECT/RESTORE
004 VIEW FORMS
PRESS VIEW KEY
006 HOST SYSTEM REQUEST ATTENTION
007 FM HEADER ERROR
008 HOLD PRINT TIMEOUT
PRESS START
009 INVALID KEY PRESS
010 PARAMETER ERROR
011 SCS COMMAND ERROR
012 STRUCTURED FIELD ERROR
013 ACTIVATE LOST
6–14 6400 Line Matrix Printers Setup Guide, Cabinet and Pedestal Models
Table 6–1. Fault Messages
Operator
Correct- Explanation
able?
Yes Printer is out of paper.
Yes No paper motion.
Yes Non-error status message.
Yes Non-error status message.
Yes Host attention message.
No Format header error.
Applications software has
violated format header
parameters.
Yes Printer was off-line more
than 10 minutes and the
"Intervention Required"
parameter is set to "Send to
Host."
Yes Appears briefly if an
inactive key is pressed in
current print mode.
No Illegal parameter value
received in command code.
No Printer received undefined
control character.
No Applications software has
violated structured data field
parameters.
No Printer detects twinax
protocol communication
errors.
Solution
Load paper according to
instructions on page 2–43.
Clear paper jam and reload
paper. See the Operator's Guide.
Reset forms thickness lever.
Press Eject/Restore key to
return paper to print position.
Press View key to return paper
to print position.
The host computer or printer
controller requires attention.
Contact your system
administrator.
Press Start to put printer in
READY state.
Re-enter the value, or press the
correct key.
Contact your system
administrator.
Contact your system
administrator.
Contact your system
administrator.
The printer reports the error.