Replacing And Removing Media; Cutting Media - Epson SC-S70600 series User Manual

Hide thumbs Also See for SC-S70600 series:
Table of Contents

Advertisement

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
E
After confirming that the settings are correct, use
the d/u buttons to select Keep Settings Above
and press the Z button.
F
The roll type selection screen is displayed.
Use the d/u buttons to select the roll type that
matches the loaded roll and press the Z button.
G
If On is selected for Remaining Setup, you will
be prompted to enter the length of the current
media.
Use the d/u buttons to choose a length between
1.0 and 999.5 m and press the Z button. You
can set in 0.5 m increments.
The printer will display Ready after a brief pause,
showing that it is ready to print. Transmit the data to be
printed from the computer.

Replacing and removing media

To replace or remove the media after printing, print the
amount of media remaining, cut the media, and remove
the roll.
Printing the Amount of Media
Remaining
The printer displays the amount of media remaining
and any media low warnings in the control panel. This
makes it possible to determine whether the media
requires replacement before printing.
The amount of media remaining can only be displayed if
the correct length is entered when the media is loaded.
You can print the amount of media remaining on the
leading edge of the roll before it is removed from the
printer and then enter this number the next time the
media is loaded for accurate information on the amount
remaining.
Note:
The printer does not calculate or display the amount of
media remaining when Off is selected for Remaining
Setup in the setup menu.
"Viewing and Changing Media Settings" on
U
page 63
Basic Operations
The following section describes how to print the
amount of media remaining.
Buttons that are used in the following settings
A
Confirm that the printer is ready to print.
B
Press the M button, select Media Remaining in
the menu, and press the Z button.
C
Select Print Remaining Length and press the
Z button.
D
Press the Z button to print the amount of
media remaining.

Cutting Media

Use a cutter (available in the market) to cut the media
when printing is complete. This section described how
to use a cutter to cut the media.
!
Caution:
❏ The heaters and media holding plate may be
hot; observe all necessary precautions. Failure
to observe the necessary precautions could
result in burns.
❏ When cutting media, be careful not to cut your
fingers or hands with the cutter or other blades.
64

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sc-s50600 seriesSc-s30600 series

Table of Contents