Epson SC-S70600 series User Manual page 147

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Item
Media Adjust
Feed Adjustment
Auto
Manual
Head Alignment
Standard
(Auto)
Standard
(Manual)
Block pattern
Heating & Drying
Heater Tempera-
ture
Drying Time Per
Pass
After Heater Feed
Additional Dryer
Advanced Settings
Using the Control Panel Menu
Parameter Explanation
Select this option to adjust media with Auto Media Adjust disabled or
make readjustment when changing printing conditions after saving
media settings.
In this menu, perform Feed Adjustment and Head Alignment
Print
individually.
Print
Adjustment types and execution procedure U
page 86
Print
Print
Manual(Uni-D)
Manual(Bi-D)
*1
Manual(Dual Head)
Pre-heater/platen The temperatures for the pre-, platen, and after heaters can each be
heater: 30˚C to 50˚C adjusted separately.
(86˚F to 122˚F)
After heater: 30˚C to
55˚C (86˚F to 131˚F)
0 to 10 sec Select the time the print head pauses to allow drying after each pass.
Choose from values between 0.0 and 10.0 seconds. The time needed for
the ink to dry varies with ink density and the media used. If the ink blurs on
the media, set a longer time for drying the ink.
Increasing the drying time increases the time needed to print.
Mode 1
To feed media to the after heater after printing, choose Mode 1 or Mode 2;
otherwise, choose Off.
Mode 2
If Mode 1 is selected, the portion fed for drying will not be rewound before
the next job starts. Select this option if the media will be cut before the next
Off
job starts.
If Mode 2 is selected, the portion fed for drying will be rewound before the
next job starts, eliminating unnecessary margin. Select this option if
multiple jobs will be printed consecutively.
On This item is displayed only when the additional print drying system
(supplied with the SC-S50600 series; optional with other models) is
Off
installed.
Select On to enable, or Off to disable, the additional print drying system
(supplied with the SC-S50600 series; optional with other models). Note
that even when On is selected, the additional print drying system will turn
off with the heaters when the Heat Off Timer expires. The additional print
drying system will turn back on when the heaters resume operation. Heat
Off TimerU
During general use, use the default setting value without changing it.
When using special media or when a problem such as head striking or
banding is detected in printing results, change the default.
"The Printer Setup Menu" on page 149
147
"Media Adjust" on