Sc-S30600 Series - Epson SC-S70600 series User Manual

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
*2 This may be available in the RIP depending on the software RIP being used. Contact the RIP manufacturer for
more information.
*3 Note the following points when setting margins.
❏
Regardless of the Media Size Check setting, the margin start point is within "A" (indicated by the broken line).
❏
If the total of the print data width and set left and right margins exceeds the printable area, a portion of the data will not be
printed.

SC-S30600 series

The gray area in the illustration below shows the printable area. The arrow indicates the feed direction.
The left and right edges of media recognized by the printer varies as shown below according to the Media Size
Check settings.
On : The printer automatically detects the left and right edges of the loaded media.
When media holding plates are attached, within 5 mm of the left and right edges of the media is
recognized as the media edge.
The edges of the media are not detected correctly if the media holding plates are not attached correctly.
"When the Standard Media Feeding Unit Is Installed" on page 51
U
"Using the Optional Heavy Roll Media Feeding Unit" on page 57
U
: The longest scale on the after heater's label (in the illustration below) is used as the reference position for
Off
the right edge of the media. Regardless of the width of the loaded media, the left edge of the media is
determined to be 1,626 mm (64 inches) from the reference position for the right edge.
Basic Operations
94