EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
A
D
to
indicates the margins on all four sides. See the following for more details.
Margin
Explanation
Position
A
*1
This can be configured in RIP. To maintain media feeding accuracy, if the settings are less
Bottom
than 5 mm or more than 17 mm, the settings are switched to 5 mm and 17 mm
respectively.
*1
This can be configured in RIP. Differs by the length the media was pulled when the media is
B
Top
loaded. For continuous printing, although the margins set in RIP are added, to maintain
media feeding accuracy, if the setting is less than 5 mm the setting is switched to 5 mm.
C
*2, *3
The value selected for Side Margin(Left) in the printer's setup menu. The default setting is
Left
5 mm.
*2, *3
D
The total of the values selected for Print Start Position and Side Margin(Right) in the
Right
printer's setup menu. The default setting for Print Start Position is 0 mm and Side
Margin(Right) is 5 mm.
*1
The configured margin and the actual print results may differ depending on the RIP being used. Contact the RIP
manufacturer for more information.
*2
This may be available in the RIP depending on the software RIP being used. Contact the RIP manufacturer for
more information.
*3
Note the following points when setting margins.
❏
Leave margins of 10 mm or more when using media holding plates. Narrower margins could result in printer printing over
the plates.
❏
If the total of the print data width and set left and right margins exceeds the printable area, a portion of the data will not be
printed.
Basic Operations
92
Available
Setting
Range
5 to 17 mm
5 mm or more
3 to 25 mm
3 to 825 mm