Epson SC-S70600 series User Manual page 93

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
When using high pressure rollers (when using transparent or milky white film or
for ink layering)
The printable area is the area excluding the margins configured from the positioning of pressure rollers. (See the gray
area in the illustration below.) The arrow indicates the feed direction. "A" indicates the position of the high pressure
rollers.
A D
to indicates the margins on all four sides. See the following for more details.
Margin Explanation
Position
A *1 This can be configured in RIP. To maintain media feeding accuracy, if the settings are less
Bottom
than 5 mm or more than 17 mm, the settings are switched to 5 mm and 17 mm
respectively.
*1
B This can be configured in RIP. Differs by the length the media was pulled when the media is
Top
loaded. For continuous printing, although the margins set in RIP are added, to maintain
media feeding accuracy, if the setting is less than 5 mm the setting is switched to 5 mm.
C *2, *3 The value selected for Side Margin(Left) in the printer's setup menu. The default setting is
Left
5 mm.
*2, *3
D The total of the values selected for Print Start Position and Side Margin(Right) in the
Right
printer's setup menu. The default setting for Print Start Position is 0 mm and Side
Margin(Right) is 5 mm.
*1 The configured margin and the actual print results may differ depending on the RIP being used. Contact the RIP
manufacturer for more information.
Basic Operations
93
Available
Setting
Range
5 to 17 mm
5 mm or more
3 to 25 mm
3 to 825 mm