Cleaning Inside The Printer (Once A Week To Once A Month) - Epson SC-S70600 series User Manual

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Right and left sides
For the SC-S70600 series and SC-S50600 series,
clean the other wiper rails in the same way.
Next, go to Step 6 in Cleaning the wiper cleaner.
"Cleaning the wiper cleaner (daily)" on page 109
U
Cleaning Inside the Printer (Once
a week to once a month)
Lint, dust, and ink accumulate on the platen heater,
pressure rollers, and media holding plates. Ink on these
surfaces may be transferred to the media. Furthermore,
if any accumulated lint or dust is left inside the left
maintenance cover, it may adhere around the print
head.
!
Caution:
❏ The heaters and media holding plate may be
hot; observe all necessary precautions. Failure
to observe the necessary precautions could
result in burns.
❏ Be careful not to trap your hands or fingers
when opening or closing the front cover.
Failure to observe this precaution could result
in injury.
c
Important:
When cleaning inside the printer, do not use ink
cleaner. Failure to observe this precaution could
result in damaged parts.
Maintenance
A
Make sure the printer is turned off and the screen
has turned off, and then unplug the power cable
from the outlet.
B
Leave the printer for a minute.
C
Open the front cover.
D
Raise the media loading lever.
E
Remove stains on the pressure rollers using a dry,
soft cloth.
SC-S70600 series/SC-S50600 series
Wipe while rotating the roller sections one by
one.
c
Important:
Ensure the cloth does not touch the shaft
above the rollers (gray area in the illustration)
when wiping. Otherwise, grease will adhere to
the cloth. If a stained cloth touches the roller,
the roller is stained with grease.
SC-S30600 series
Slide a dry cloth between the pressure rollers and
the platen and over the upper part of the pressure
rollers to wipe the area.
c
Important:
Do not press strongly on the rollers when
wiping. This may detach the rollers.
113