Denon AVR-5803 Operating Instructions Manual page 58

6 $ Select the various surround parameters. $ Adjust the parameters setting.
l
DEFAULT setting
This operation cannot be performed by operating the buttons on the main unit.
Select "Default Yes 4", then parameters set to default setting.
-
3% Stop pressing main unit's buttons once you have completed setting the surround parameters. After several seconds the normal display
reappears and the settings you have made are automatically set.
NOTE:
l
When making parameter settings, the display will return to the regular condition several seconds after the last button was pressed and the
setting will be completed.
Surround parameters f@
Pro Logic II Mode:
The Cinema mode is for use with stereo television shows and all programs encoded Dolby Surround.
The Music mode is recommended as the standard mode for autosound music systems (no video). and IS optional for A/V systems.
The Pro Logic Emulation mode offers the same robust surround processing as origrnal Pro Logic in case the source contents is not of optimum
quality.
Select one of the modes ("Cinema", "Music" or "EML").
It is possible to switch to the direct mode using the CINEMA/MUSIC button on the main unit's panel.
Panorama Control:
This mode extends the front stereo image to include the surround speakers for an exciting "wraparound" effect with side wall imaging.
Select "OFF" or "ON".
Dimension Control:
This control gradually adjust the soundfield either towards the front or towards the rear.
The control can be set in 7 steps from 0 to 6.
Center Width Control:
This control adjust the center image so it may be heard only from the center speaker; only from the left/right speakers as a phantom image;
or from all three front speakers to varying degrees.
The control can be set in 8 steps from 0 to 7.
DTS NEti6 MUSIC:
CENTER IMAGE (0.0 to 0.5: default 0.2)
The center image parameter for adjusting the expansion of the center channel in the DTS NEO:6 MUSIC mode has been added.
58