Denon AVR-5803 Operating Instructions Manual page 24

6
Set the distance between the
lUlMP
center speaker and listening
position.
The distance changes in units of
0.1 foot (0.03 meters) each time
the button is pressed. Select the
value closest to the measured
distance.
Example: When the distance is set to
12 feet
for the
center speaker
6L A 410. Oft,
% If "Yes" is selected for "Default", the settings are automatically reset
to the default values.
Please note that the difference of distance for every speaker should be 20
ft (6.0 m) or less. If you set an invalid distance, a CAUTION notice, such
as screen right will appear. In this case, please relocate the blinking
speaker(s) so that Its distance is no larger than the value shown in
highlighted line.
7
Mwm
Enter the setting.
The System Setup Menu reappears.
The AVR-5803 automatically sets the optimum surround delay time for the listening room
l
Use this setting to adjust so that the playback level between the different channels is equal.
l
From the listening position, listen to the test tones produced from the speakers to adjust the level
l
The level can also be adjusted directly from the remote control unit. (For details, see page 48.)
l
When using both surround speakers A and 6, their playback levels can be adjusted separately.
At the System Setup Menu select "Channel Level"
1
System Setup Menu
Speaker Configuration
Delay Time
FChanne I Leve I
THX Audio Setup
Suhroofrr Peak Limit Lev.
Digital In Assignment
;ideo Input Mode
2
-(*(I
Switch to the Channel Level screen
Channe I Leve I
ETest Tone ml :b@Zl
Test Tone Start m(
3
Select "Test Tone Mode"
24