Denon AVR-5803 Operating Instructions Manual page 41

3
Adjust as desired with the CONTROL
knob.
l
To increase the bass or treble:
Turn the control clockwise. (The bass
IMafn unlti
or treble sound can be increased to
up to +I 2 df3 in steps of 2 dB.)
l
To decrease the bass or treble:
Turn the control counter clockwise. (The bass or treble
sound can be decreased to up to -12 dB in steps of 2 dB.)
4 If you do not want the bass and treble to be
adjusted, turn on the tone defeat mode.
TONE
DEFEAT
% The signals do not pass through the bass
and treble adjustment circuits, providing
higher quality sound.
%
IMan unit)
[21 Listening over headphones
Plug the headphones' plug into the jack.
.X Connect the headphones to the PHONES jack.
The pre-out output (including the speaker output) is automatrcally
turned off when headphones are connected.
NOTE:
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
131 Turning the sound off temporarily (muting)
1
1 Use this to turn off the audio output -
temporarily.
Press the MUTE button.
% Cancellina MUTING mode.
Press the-MUTE button again.
W2mote control unit)
[41 Combining the currently playing sound with the desired image
Simulcast playback
Use this switch to monitor a video
source other than the audio source.
VIDEO
SELECT
Press the remote control unit's VIDEO
SELECT button until the desired image
P
appears.
Fwnote control unit)
*X Cancelling simulcast playback.
l
Select "SOURCE" using the video select button.
l
Switch the program source to the component connected to
the video input.
[51 Checking the currently playing program source, etc.
-1
-1
1
1
On screen display
l
Each time an operatron is performed, a
description of that operation appears
on the display connected to the unit's
VIDEO MONITOR OUT jack. Also, the
unit's operating status can be checked
during playback by pressing the remote
control unit's ON SCREEN button.
,aemote cOntrO, Uniti
Such information as the position of the
input selector and the surround
parameter settrngs is output in
sequence.
Front panel display
. Descriptions of the unit's operations
STATUS
are also displayed on the front panel
display. In additron, the display can be
switched to check the unit's operating
status while playing a source by T
pressing the STATUS button.
(Man unit1
Using the dimmer function
l
Use this to change the brightness of the
display.
The display brightness changes in four steps
(bright, medium, dim and off) by pressing the
remote control unit's DIMMER button
repeatedly.
R?nme COntlOl lmti
% The brightness changes in 3 steps each time
the button is pressed, and finally the display
turns off.
[6] Switching the surround speakers
1 The surround speakers switch as
shown below each trme the SPEAKER
button is pressed.
SURROUND A --) SURROUND B
SURROUND A+8
1Aemote control unit)
% This operation is possible when the setting for using both
surround speakers A and B is made at "Speaker
Configuration" in the System Setup Menu.
41