Denon AVR-5803 Operating Instructions Manual page 106

@ Press the - and - buttons in the icon
display section to drsplay the DVD icon, then
press the DVD Icon to select it.
Here, press the DVD "ON" and "PLAY"
buttons.
% To select buttons on other pages, press the
JOG switch's left and right buttons to swatch
the page.
After the buttons are registered, press the
"END" button.
When the "END" button is pressed, the drsplay
switches to a confirmation screen.
@ The buttons registered rn steps @ and @ are
displayed on the confirmation screen.
Press the "OK" button to register the system
call settings. The system call button name
swatches from gray to black.
The system call signals are stored at the open
system call button with the lowest number.
% Initially they are stored at "CALL 1"
Screen @ Screen @
._" _" .,"__" "" ,,, ._" _" .,"__" "" ,,,
Screen @
[31 Editing registered system call settings
@ Press "SETUP" on the icon display section for 3
seconds to display the setup screen.
Press the "Sys. Call Setup" button on the
"Setup 3/4" page to display the system call
selection screen.
Screen 0
@ Press the - and - buttons on the call list
to drsplay the system call button you want to
edit
Press the system call button you want to edit so
that it is displayed rn half-tone dot mesh, then
press the "EDIT" button to set the system call
edit mode.
Screen 0
@I Editing system call settrngs
a-1 Changing the delay time
By default, the delay time IS set to 0.7
seconds.
The delay time can be changed to anything
Screen 0
____._ -._- .._....I
between 0 and 10 seconds rn steps of 0.1
second.
The delay times at the right of the buttons
indicate the time from which the signal for
that button is sent until the signal for the
next button is sent.
a. Press the button on the system call
editing screen's button lrst whose delay
trme you want to change so that it is
displayed rn half-tone dot mesh.
b. Press the A and 7 buttons at the
bottom right of the editing screen to set
the desrred delay time.