Denon AVR-5803 Operating Instructions Manual page 30

l
Select the input signal to be output from the video monitor output terminal. (For details, refer to page 81.)
At the System Setup Menu select "Video Input Mode"
System Setup Menu
Speaker Configuration
Delay Time
Channel Level
THX Audio Setup
Subwooftr Peak Limit Lev.
Digital In Assignment
Wide0 Input Mode
0
2
Mill
Switch to the Video Input Mode screen.
Video lnpu t Mode
m: 4 AUTO
b
m: AUTO
m: AUTO
m: AUTO
Iv.AuxI: AUTO
Default E44
3
cl? Select the input source for which you
\..
want to set the Video Input Mode.
G? Select the mode
AUTO: When there are multiple input signals, the Input signals are detected and the Input signal to be output from the video
monitor output terminal is selected automatically in the following order: component video, S-Video, composite video.
Component: The signal connected to the component video terminal is always played.
Video conversion is not conducted, so no image is output from the monitor output terminal when there is no input signal
to the component terminal.
Only DVD, TV and DBS can be selected.
S-Video: The signal connected to the S-Video terminal is always played.
The S-Video input signal is up-converted and output from the component monitor output terminal.
Video: The signal connected to the composite video terminal is always played.
The composite video input signal is up-converted and output from the S-Video and component monitor output terminals.
NOTE:
Down-converting from the component video signal to the S-Video and composite video signal IS not possible, so when not using the
component video monitor output terminal connect the player using the S-Video or composite video input terminal.
4
MI-
Enter the setting.
The System Setup Menu reappears.
This function allows you to adjust the time delay of the video and audio signals and store these settings for the different input sources
The setting is made while watching a DVD or other software, so it is not made here.
By default, this is not displayed when no digital signals are being input.
For instructions on making the setting, refer to page 56.
30