Table of Contents
Advertisement
11 TUNING THE CHASSIS
11.15
58
W00322-10
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
W00323-10
(All special models)
The holes on the handlebar supports are placed at a distance
A
of
from the center.
3.5 mm (0.138 in)
A
Hole distance
The handlebar supports can be mounted in two different posi-
tions.
(All EXC-F, XW-F)
–
1
Remove screws
. Take off the handlebar clamp. Take
off the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables or lines.
–
2
Remove screws
. Take off the handlebar support.
–
Place the handlebar support in the required position.
Mount and tighten screws
Guideline
Screw, handle-
M10
bar holder
Info
Position the handlebar support so that it is even.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
2
.
40 Nm (29.5 lbf ft)
Loctite
®
243™
Advertisement
Table of Contents
