Selecting The Operating Band; Selecting A Tuning Step - Icom ID-51A Basic Instructions

4
BASIC OPERATION

■ Selecting the operating band

The transceiver can receive the AIR, 144 MHz or 430 MHz
bands.
q Push [V/MHz]
the VFO mode.
Push [QUICK]
w
Push D-pad( )
e
"Band Select," and then push
D-pad(Ent).
D-pad
(Ent)
(�)
Push D-pad( ) to select the
r
desired frequency band.
• Available frequency bands are
differ, depending on version.
See the specifications for de-
tails. (p. 89)
Push D-pad(Ent) to set and
t
exit the Quick Menu screen.
33
to select
.
to select
430 MHz band
144 MHz band

■ Selecting a tuning step

Rotating [DIAL] changes the frequency in the selected tuning
steps.
The VFO scan uses this step when searching for signals.
The following tuning steps are selectable. (kHz)
5.0 6.25
25.0 30.0
*Appears only when the AIR band is selected.
D Tuning step selection
Push [QUICK]
q
Push D-pad(
w
and then push D-pad(Ent).
D-pad
(Ent)
(�)
Push D-pad(
e
desired tuning step.
AIR band
• You can set the tuning step
for both the VFO and Memory
modes.
Push D-pad(Ent) to save the
r
setting and exit the Quick
Menu screen.
8.33* 10.0 12.5
50.0 100.0 125.0
.
) to select "TS,"
) to select the
When 5.0 kHz tuning
steps is selected.
15.0 20.0
200.0