Chevrolet 1980 Light Duty Truck Repair Manual page 333

F i g . 7 A - 1 4 6 C - l n s t a l l i n g F r o n t I n t e r n a l G e a r R i n g t o O u t p u t
C a r r i e r
13. Install front internal gear ring over output carrier
(Fig. 7A -146C ).
14. Install sun gear shaft w ith long splined end down.
15. Install reaction carrier (Fig. 7A -147C ).
Fig. 7A-1 47 C — Installing Reaction Carrier
A U TO M A TIC TR A N S M IS S IO N S
THRUST BEARING
Fig . 7 A - 1 4 8 C - l n s t a l l i n g C e n t e r S u p p o r t t o S u n G e a r T h r u s t
B e a r i n g a n d R a c e s
NO TICE:
W hen a new output carrier a n d /o r reaction
carrier is being installed and if the front internal gear
ring prevents assem bly o f the carriers, replace the front
internal gear ring w ith the SER VICE ring.
16. Install center support to sun gear thrust races and
bearings as follows: (Retain with petrolatum ).
a. Install large race, center flange up over sun gear
shaft.
b. Install thrust bearing against race.
c. Install second race, center flange up (Fig. 7A -148C ).
17. Install rollers that may have com e out o f the roller
clutch cage, by com pressing the energizing spring with
forefinger and inserting roller from the outer edge (Fig. 7A -
149C).
Fig. 7A-1 4 9 C -ln s ta llin g Roller into Roller Clutch Cage
(4 0 0 )7 A-47
S U N GEAR
SHAFT
I.D . FLANGED
RACE
I.D . FLANGED
RACE