Manual Shaft And Parking P A W L; Rem Oval - Chevrolet 1980 Light Duty Truck Repair Manual

7A1-10 AUTOMATIC TRANSMISSION (200)
Figure 7A1-43 Removing Front Carrier and Roller Thrust
Bearing
Figure 7A1-44 Removing Thrust Bearing Assembly and Front
Sun Gear
Figure 7A1-45 Removing Input Drum and Rear Sun Gear
a. Rem ove rear internal gear to rear sun gear roller
thrust bearing assembly o ff rear internal gear.
b. R em ove rear internal gear o ff output shaft. (Figure
7A1-52).
5. Turn transmission to horizontal position and remove
J-25013-5 and J-25013-1 tools from case. Turn transmission
to vertical position with rear end up.
6. If necessary, rem ove real oil seal. (Figure 7A 1-53).
M A N U A L SHAFT AND PARKING
PA W L PARTS (FIGURE 7A1-54)

Rem oval

1. Turn transmission to horizontal position, oil pan side
up.
F R O N T C A R R IE R
L L E R T H R U S T
A R IN G A SSY.
F R O N T S U N G E A R
T H R U S T B E A R IN G A SSY.
f ■ :#
6 07C 39
IN P U T
D R U M
Figure 7A1-46 Removing Cup Plug and Seal Assembly
S N A P
R IN G
Figure 7A1-47 Removing Lo and Reverse Housing to Case
Snap Ring
Figure 7A1-48 Removing Low and Reverse Clutch Housing
2. If necessary, remove manual shaft and parking
linkage as follows:
a. R em ove hex nut which holds inside detent lever to
manual shaft. (Figure 7A1-55).