Chevrolet 1980 Light Duty Truck Repair Manual page 280

(350)7A -32 A U TO M A TIC TR A N SM IS S IO N
Fi g . 7 A - 9 8 B ~ l n s t a l l i n g E x t e n s i o n H o u s i n g B u s h i n g
housing bushing in housing flush to .010 below seal counter
bore surface using tool J-21424-9 with drive handle J-8092
(fig. 7A -98B ).
Output Shaft Bushing
W ith output shaft properly supported, rem ove bushing
using remover J-9534-01 and slide hammer J-7004 (fig. 7A -
99B). U sing tool J-23062-7, install bushing until tool
bottom s on output shaft.
Case Bushing
W ith case properly supported, drive out bushing from
rear o f case using tool J-23062-1 and drive handle J-8092.
OUTPUT RING GEAR
ADAPTER
Fig. 7A-99B~Removing Output Shaft Bushing
OVERHAUL MANUAL
J - 8 0 9 2
J - 2 1 4 2 4 - 9
E X T E N S IO N
H O U S I N G
OUTPUT SHAFT
J-9534
SLIDE HAMMER
J - 2 1 4 6 5 - 1 5
PUMP C O V E R
A N D STATOR
SHAFT ASSEMBLY
Fi g. 7 A -1 O O B - R e m o v i n g S t a t o r S h a f t F r o n t B u s h i n g
U sing tool J-23062-1 and drive handle J-8092 with extension
J-2 1465-1J, install bushing from interior o f case to 3/16"
from front surface w ith crim pled line in bushing located
between the 10 o 'clock and the 2 o 'clock position.
Stator Shaft Front Bushing
W ith stator shaft properly supported, rem ove front
bushing using tool J-21465-16 and slide ham m er w ith
adapter J-2619-01 (fig. 7A -100B ). U sing tool J-21242-7 and
drive handle J-8092, install bushing to .250" from face (fig.
7A -101B ).
J-8092
DRIVE
HANDLE
PUMP COVER
AND STATOR
SHAFT ASSEMBLY
Fig. 7A-101 B--Installing Stator Shaft Front Bushing
J - 2 6 1 9 - 4
ADAPTER
B O D Y PUMP
J-21424-7
PUMP
BODY