7A 5-20 A U TO M A TIC TR A N SM IS S IO N
REACTION
CARRIER
OUTPUT RING GEAR
A N D OUTPUT SHAFT
Figure 7A 5-83 Reaction Carrier
8.
Lubricate and install low reverse clutch steel reaction
plates and face plates, starting with a steel plate and
alternating w ith face plates. Install low and reverse clutch
support retainer spring (anti-clunk) spring.
[ANTI-CLUNK!
SPRING
i
Figure 7A 5-84 Anti Clunk Spring Piston
N otch in steel separator plates should be placed toward
bottom o f case.
9. Install low and reverse clutch support assembly.
(Figure 7A 5-85)
Make certain the splines on inner race o f the roller
clutch align w ith splines on reaction carrier.
10. Install low and reverse clutch support to case snap
ring with anti-clunk spring between gap.
11. Install sun gear thrust washer onto roller clutch
race.
12. Install sun gear drive shell assembly.
13. Install output carrier assembly.
14. Install input ring gear rear thrust washer.
15. Install input ring gear to output shaft snap ring.
16. Install input ring gear.
7C-209
Figure
S U N G E A R D R IV E
SHELL A S S E M B L Y
■
Figure 7A 5-86 Sun Gear Drive Shell
LOW A N D REVERSE
CLUTCH SUPPORT
LOW A N D REVERSE
CLUTCH SUPPORT
RETAINER SPRING
7A 5-85 Low & Reverse Clutch Support
t ■ r # *
O U T P U T C A R R IE R A S S E M B L Y
Figure 7A5-87 Output Carrier
7C-210