Operating System; Battery Details; Battery Safety; Battery Swap Time - Motorola Omnii User Manual

Operating System

• Microsoft® Windows® Embedded Hand-Held 6.5

Battery Details

Omnii Hand-Held Computers operate by lithium-ion battery packs, Model ST3001.
Review the following sections for detailed battery information:
• Installation: "Preparing the Omnii for Operation" on page
• Power settings:
• Chargers and docking stations:
• Specifications:
• Contact pinout:

Battery Safety

IMPORTANT

Battery Swap Time

Assuming the default power saving parameters and battery reserve level have not been altered, battery swap
time is a minimum of 4 minutes — you will not lose data if the battery is replaced within this time frame.
To protect data, the safest place to store data is on a microSD memory card or externally on a USB memory
stick or on a PC. You can also save data in the "Flash Disk" partition of the file system.
Refer to "Suspend Threshold and Estimated Battery Backup" on page 4-10
power for data backup purposes.
The Suspend Threshold adjustment in the Power Properties tab allows you to determine the battery capacity at
which the Omnii will be shut down. If left at the default value, Maximum Operating Time, the unit will run until
the battery is completely empty; the RAM is only backed up for a short period of time. If you choose Maximum
Backup Time, the Omnii shuts off with more energy left in the battery so RAM can be backed up for a longer
period of time.
IMPORTANT
"Power" on page 4-9.
Chapter 5:
"Lithium-ion Smart Battery 5000 mAh (ST3001)" on page
"Omnii Battery Contacts" on page
Before attempting to install, use, or charge the battery pack, it is crit-
ical that you review and follow the important safety guidelines in the
quick reference guide entitled Omnii Hand-Held Computer Regula-
tory & Warranty Guide, PN 8000191.
If your Omnii fails to power up, consider the following troubleshooting options:
The battery may be overheated (>60C°), a non-Motorola battery may be
installed, or the battery may have fallen below the configured Suspend
Threshold. See "Suspend Threshold and Estimated Battery Backup" on
page 4-10 for details.
To switch on the hand-held, you will need to replace the overheated battery.
However, if you supply AC power to the Omnii with a battery that falls
below the configured Suspend Threshold, the unit will switch on.
Getting To Know Your Omnii 2 - 5
1-5.
"Accessories".
A-6.
E-5.
for details about reserving battery