Wi-Fi Config: Advanced Tab; Country Options - Motorola Omnii User Manual

Name Servers
If you tap on the Name Servers tab at the top of the screen, you can statically configure the DNS servers;
however, if you use DHCP for IP address assignment, DNS is usually supplied by the same server that
supplied the IP addresses.

Wi-Fi Config: Advanced Tab

This screen provides a number of options which are described in this section.

Country Options

IMPORTANT
Wireless Zero Config
If you prefer to use Wireless Zero Config, the Windows native supplicant, to configure the radio:
• Tap on the Advanced tab, and tap on the checkbox to the left of Use Windows to configure my wireless
settings to add a check mark and activate this option.
Network Type
This option allows you to select the full set or a sub-set of the IEEE 802.11 wireless network protocols. You can
choose from the following:
• b only: forces the radio to operate in the 2.4GHz band only. The hand-held will only associate with an
Access Point (AP) that supports the DSSS data rates 1, 2, 5.5 & 11 Mbps. This mode has the lowest data
rate but yields the longest range.
• b/g only: forces the radio to operate in the 2.4 GHz band only. The Omnii will only associate with an AP
that supports the DSSS data rates 1, 2, 5.5 & 11 Mbps and OFDM data rates: 6, 9, 12, 18, 24, 36, 48,
54Mbps. This mode offers the same range as b only mode but with higher data rate of 54 Mbps when
possible
• a only: forces the radio to operate in the 5 GHz band only. The hand-held will only associate with an AP
that supports the OFDM data rates: 6, 9, 12, 18, 24, 36, 48, 54 Mbps.
11n Mode
802.11d is enabled by default for auto-country detection. If you are having diffi-
culty associating with your access point, you may need to disable 802.11d and
choose your country.
In the Wi-Fi Config>Advanced tab, choose Country Option. In the drop-down
menu, choose your country.
Tap here to add a check mark
to activate Windows radio
configuration.
Settings 4 - 41