Restoring Default Settings; Decoded (Internal) Scanners; Options - Motorola Omnii User Manual

C - 4 Omnii (Windows Embedded Hand-Held 6.5) User Guide
IMPORTANT
Keep in mind that some barcode types are only available when an internal imaging scanner is installed. All
internal scanners can be configured using these dialog boxes.

Restoring Default Settings

If you want to restore the factory defaults after making changes, the defaults can be applied to a selected
parameter, sub-tree of parameters, or all scanner parameters.
• Press and hold the stylus on a symbology to display a pop up a menu.
• Choose Default parameter to reset only the parameter you selected, or choose Default all settings to
reset all scanner parameters to default settings.

Decoded (Internal) Scanners

• Tap on the Scanner drop-down menu, and choose Decoded (internal).

Options

NOTE
Some options are available only for specific scanners. Refer to the option
names in this section for scanner model identification.
Dot Time (msec)
The value selected for Dot Time (msec) determines (in milliseconds) how long the targeting dot remains on
before the scanner switches to a normal scan sweep. When you double-tap on this parameter, a dialog box is
displayed in which you can enter a value of 0 msec, 200 msec or 400 msec. A value of 0 (zero) disables the
target dot.
Laser On Time
The value assigned to this parameter determines how long the laser will remain on when the scan button or
trigger is pressed.
Double-tapping on this parameter displays a dialog box in which you can enter a value between 5 and 99. The
value is measured in tenths of seconds.
To improve the decode speed and performance, enable (set to 'on')
only those codes that are required by the application.