Ac Wall Adaptor - Models St1050 And St1050-Ar; Vehicle Power Outlet Adaptor - Model St3113 - Motorola Omnii User Manual

5 - 8 Omnii (Windows Embedded Hand-Held 6.5) User Guide
To attach the Snap Module charger to Omnii:
• Make sure that the charger connector and Omnii docking connector are free of dust or any other debris
before connecting them.
• A slot in the side rail on each side of the hand-held accommodates the locking clips of the charger. To
attach the charger, align it with the base of the hand-held and gently slide up until the locking clips snap
into place (Refer to
• To remove the charger, press down on the base of the clip arms to release them from the Omnii side rails
and slide the adaptor off.
• Connect the charger to an AC or DC power source using the appropriate regional plug or cable. Then
connect the charger's DC plug into the Snap Module's DC jack. You can also attach an ST4001 or
ST4005 Snap Module to the Omnii and use the Omnii battery to power USB or serial peripherals, for
enhanced mobility.
NOTE
If you are using a hand strap, there is no need to remove it before installing the
Snap Module, since the Omnii hand strap slot will still be accessible.

AC Wall Adaptor - Models ST1050 and ST1050-AR

The AC wall adaptor available for your docking station or Snap Module allows you to operate your hand-held
using AC power while charging the battery inserted in the unit.
The ST1050 is shipped with adaptor plugs suitable for use in the following regions: United Kingdom, Australia,
Europe and North America.
• Choose the adaptor plug that is suitable for use in your country. Slide the adaptor plug into the Universal
AC power supply, snapping it into place. These two pieces, coupled together, are referred to as an AC wall
adaptor.
• Insert the DC plug into the docking station or Snap Module jack.
• Plug the pronged end into an AC outlet.
ST1050 AC Wall Adaptor and plugs
Figure 5-7
The ST1050-AR wall adapter is kitted with an AC plug that is suitable for use in Argentina.

Vehicle Power Outlet Adaptor - Model ST3113

The Vehicle Power Outlet Adaptor allows you to power your hand-held and recharge your battery using power
drawn from your vehicle's automotive power outlet when used in conjunction with a Snap Module.
Figure 5-6 Snap Module Installation on page
AC power supply
5-7).
Adaptor plugs
DC power plug