Optional Multi-Hopper; Prepare The Printer For Cleaning - DataCard CD800 User Manual

Optional Multi-Hopper

Cleaning a printer equipped with the optional multi‐hopper involves two steps:
cleaning the printer and cleaning the hopper rollers. To start the cleaning process,
refer to Prepare the Printer for Cleaning.

Prepare the Printer for Cleaning

1.
Power on the printer.
2.
Unlock the printer and open the printer
supplies access door.
3.
Open the printer cover and remove the
print ribbon cartridge.
4.
Remove the cleaning sleeve from the
ribbon cartridge. (The ribbon must
remain installed on the ribbon cartridge.)
5.
Replace the ribbon cartridge in the
printer and close the cover.
6.
Open the multi‐hopper door and remove
any unprinted cards.
7.
Open the cleaning card package,
remove the cards, and insert the
cleaning cards into the hoppers. (Plan
to run the cleaning cards immediately.
The cleaning cards dry out if they are
out of the package for more than a
few minutes.)
8.
Close the multi‐hopper door and lock
the printer. The front panel displays
Ready
green.
Continue with "Clean the Printer" on page 36.
CD800 Card Printer User's Guide
and the U light shows steady
SER
35