199: L2 Area Card Problem; 200: Laminator Exit Card Problem; 201: L1 Supply Problem; 202: L1 Supply Out Or Missing - DataCard CD800 User Manual

199: L2 area card problem

The card is not where it should be in the laminator.
1.
Open the laminator and remove the L2 supply cartridge.
2.
Turn the knob to remove the card.
3.
Replace the supply cartridge and close the laminator.

200: Laminator exit card problem

The card is not where it should be in the laminator.
1.
Open the laminator.
2.
Turn the knob to remove the card.
3.
Close the laminator.

201: L1 supply problem

The L1 supply is not moving properly. To try another card:
1.
Open the laminator and remove the L1 cartridge.
2.
Reposition, repair, or replace the supply and advance the repaired area one
full turn.
3.
Replace the cartridge and close the laminator.

202: L1 supply out or missing

The laminator does not have usable supplies.
1.
Open the laminator.
2.
Replace the supply.
3.
Close the laminator.

203: L1 supply type problem

The laminator cannot use the supply installed.
Use supplies designed for this laminator.

204: L1 supply not supported

The laminator cannot use the supply installed.
Use supplies designed for this laminator.
78 Troubleshooting