DataCard CD800 User Manual page 48

3.
Remove the used cleaning card. Wait a few minutes for the rollers to dry.
4.
Prepare the printer for use.
A.
B.
C.
D.
E.
H & T
INTS
Use the cleaning card and cleaning sleeve one time only.
•
Change the cleaning sleeve each time you clean the printer or change the
•
print ribbon.
34
The printer moves the card through the printer several times and ejects it
into the output hopper.
If you are cleaning a system with a laminator, the cleaning card moves into
the laminator after cleaning the printer and cleans the laminator rollers and
card entry area. The cleaning card is ejected into the laminator output
hopper.
Unlock the printer, if necessary.
Replace the cards in the input hopper.
Install a new cleaning sleeve on the ribbon cartridge and remove the
protective cover. Refer to "Load the Cleaning Sleeve" on page 23 for the
steps to follow.
Replace the ribbon cartridge and close the printer cover. Press down on
the ridges on the front of the cover to latch it properly.
Press the User button to return the printer to
available to print cards again.
Discard the used cleaning card and cleaning sleeve.
IPS
If the card light is blinking amber and there are cards in the input hopper, the
printer's configured cleaning count has been reached and it is time to clean the
printer. The cleaning count is set in Printer Manager. Refer to the printer's
Installation and Administrator's Guide for complete information about using
Printer Manager.
Ready
. The printer is
System Maintenance